Heat not working in house on the first cold night? Most no-heat calls in Las Vegas come down to the thermostat or the power. A clogged filter is the next suspect. Check all three in 10 minutes. If they look fine, the fault lies in the furnace or heat pump. A gas smell or carbon monoxide (CO) alarm means you leave the house and call for help.
This guide is for homeowners whose heat failed on the first cold night of the season. On a 115°F July day, your air conditioner runs 16 or more hours a day, and haboob dust coats the filter. By the first cold night, the heating system has sat idle for seven or more months. Work in order, from the safest steps to the ones that need a technician.
Quick answer: Why is my heat not working?
- Set the thermostat to HEAT, above room temperature.
- Confirm the furnace breaker and power switch are on.
- Replace a clogged or dusty air filter.
- Confirm gas supply, then watch ignition and error light.
- Inspect a heat pump for defrost steam or ice.
- Leave and call for gas smell or CO alarms.
Furnace households do steps 1 to 4. Heat pump households do steps 1 to 3, then 5. Step 6 applies to all.
Step 1: Check the thermostat
Why is my heat not kicking on in my house?
A thermostat left in COOL or OFF after summer is the first culprit.
- Set the mode to HEAT and the temperature a few degrees above the room reading. COOL or OFF keeps the heating equipment from starting.
- Turn off any smart-thermostat schedule or eco mode that overrides your setting.
- Replace the batteries if the display is blank or dim.
- Set the fan to AUTO because the ON setting keeps the blower pushing unheated air between heating cycles.
Heat pump thermostats also show AUX or EM HEAT, backup-heat settings that Step 5 explains.
Step 2: Check power and reset the system
How do I reset my heating system?
You can reset a heating system in four safe steps.
- Find the breaker for the heating system in the electrical panel. If it is tripped, flip it fully off, then on, one time only. If it trips again, stop and call a technician.
- Find the furnace power switch, which looks like a light switch, on or near the unit in the attic or garage. Make sure it is ON. It’s a hassle to climb into a dusty attic just to flip a switch, but that costs far less than a service call for a switch that was off.
- Seat the door panel on the furnace firmly. A door safety switch cuts power when the panel is loose.
- Turn the thermostat off, wait about 5 minutes, then turn it back on.
When the circuit board is the problem
If the unit stays dead, the fault lies in the circuit board or controller. Measuring voltage and replacing a fuse are technician jobs, and opening the panel risks a shock.

Step 3: Check the filter and vents
A clogged filter chokes the airflow. The furnace overheats, and a safety switch called the high-limit switch shuts off the burners. It then cycles on and off in short bursts or blows lukewarm air.
Summer dust loads Las Vegas filters fast, and many homes never change the filter when the season switches from cooling to heating.
- Replace the filter if you cannot see light through it.
- Point the new filter’s arrow toward the furnace, or toward the air handler, the indoor box that holds the blower in a heat pump home.
- Open every vent and return grille so furniture does not block the airflow.

Fine desert dust settles on an idle furnace all summer, and haboob storms add more. Heavy dust on the blower and burners inside the cabinet calls for our furnace cleaning service.
Not sure how dirty the inside is? The signs that your furnace needs cleaning show when a new filter is not enough.
Step 4: Gas furnace checks
A furnace with power but no heat has a gas or ignition issue.
- Gas supply. Confirm that the stove or water heater still works and that your Southwest Gas service is active. Make sure the gas valve at the unit is ON.
- Ignition. Many Las Vegas furnaces use a hot surface igniter, a small ceramic part that glows to light the gas. It is fragile, so if it tries to light and then stops, call a technician. Do not relight a pilot yourself.
- Error light. Furnaces flash a diagnostic code through a sight window. Note the pattern for the technician.
- First-run smell. A short burning-dust smell on the first cold night is common after months unused. A smell that lingers or turns to burning plastic or an electrical odor means to shut the system off and call.

Las Vegas furnaces sit in attics and garages, so keep the area around yours clear of stored boxes.
Why is my house blowing cold air even though the heat is on?
Cool air at the vents comes from a fan set to ON or a heat pump defrost cycle, and Steps 1 and 5 explain both. Cool air during the first minute of a heating cycle is normal. A furnace that keeps blowing cold air has an ignition or limit-switch fault that needs a technician.

Step 5: Heat pump checks
A heat pump home has an outdoor unit and an indoor air handler. Heat pump air feels cooler than furnace air, and that is normal. It still heats the house.
When the weather turns cold and damp, frost builds up on the outdoor coil, so the system briefly runs in reverse to melt it. Steam and brief cool air indoors are normal.
- Iced or silent outdoor unit. Clear debris from around it and never chip the ice. If it stays iced or the fan will not run, call a technician.
- Emergency heat. AUX is the automatic backup heat, and EM HEAT is the manual setting. Both run electric heat strips, and EM HEAT is a costly stopgap, so call soon.
Is the air handler getting power?
The air handler sits in the attic or a closet and runs on its own breaker and power switch, so confirm both are ON before you call.
When there is no heat is an emergency
- Gas smell. Do not touch switches or the thermostat. Leave the building, then call Southwest Gas and 911 from a safe place.
- CO alarm or symptoms. The Centers for Disease Control and Prevention (CDC) lists headache, dizziness, weakness, upset stomach, vomiting, chest pain, and confusion as symptoms. Get everyone outside and call 911. More than 400 Americans die each year from unintentional CO poisoning not linked to fires. Install battery-operated or battery-backup detectors near every sleeping area, and have gas heating serviced yearly by a qualified technician.
- Burning plastic or electrical smell, or a breaker that keeps tripping. Turn the system off at the thermostat and the power switch, then call.
- Loud bang at ignition. Shut the unit down at its power switch and call a technician.
Should I turn off my heat if it’s not working?
Turn it off if it cycles on and off in short bursts or trips a breaker, and leave it off after two failed restarts. For emergency heating repair, call a licensed heating technician right away.
How long can a Las Vegas house go without heat?
No fixed number applies, and the risk here is lower than in cold climates but real. The National Weather Service’s climate summary for Las Vegas says the coldest winter nights in the Valley drop into the 20s. Readings in the teens or lower come only in the most severe cold outbreaks.
A cold house is hardest on infants and older adults, and it puts pipes in garages and exterior walls at risk. A space heater bridges the gap when you plug it directly into a wall outlet and keep it 3 feet from anything that burns, such as bedding or curtains. Choose a model with a tip-over switch. Never heat a house with a gas oven or a charcoal grill, and never run a generator inside your home or garage.
Your next step: the right guide for your symptom
- Heat pump running but not heating: heat pump not heating
- Furnace blowing cold air: furnace blowing cold air
- What the repair costs: furnace repair cost
- Worried about carbon monoxide: furnace carbon monoxide warning signs
- Old furnace, repeated repairs: when to replace your furnace
- Furnace works but smells or struggles: signs your furnace needs cleaning
- Cleaning cost: furnace cleaning cost in Las Vegas
- Prevent it next year: annual furnace tune-up checklist
- Want a technician now? See the last section below
When the six checks don’t bring the heat back
If the six checks did not restore the heat, the fault needs a technician. One of Bob’s customers had the heater checked after a summer system install:
Highly recommend Bob’s for HVAC work. We had a new HVAC system installed during the hottest period of the summer – 108 degrees – and they did a great job. Since it was so hot, we didn’t test out the heater, so they came yesterday to do a maintenance, change filter and check out the heater. Very professional and as I said, I’d highly recommend.
Call Bob’s Repair at (702) 381-5080 for heating repair in Las Vegas.


