Book An Appointment Call (702) 381-5080

Calls answered 24/7 · Service 7 AM–10 PM daily

Heat Pump Blowing Cold Air in Heat Mode? A Failing Reversing Valve in Las Vegas

When a heat pump blows cold air in heat mode, the reversing valve is one of the first parts to check. That valve flips the direction refrigerant flows, so the same system can cool in summer and heat in winter, and when it sticks, the system can stay stuck in cooling. Low refrigerant, a weak compressor, and a normal defrost cycle are the other usual causes. On August 10, 2026, we found a failing reversing valve and a failing compressor on a heat pump at a Las Vegas home in the 89118 ZIP, and recommended replacing the system.

Heat Pump Blowing Cold Air in Heat Mode? A Failing Reversing Valve in Las Vegas

What We Found

The homeowner called because one room wasn’t getting enough air. At the outdoor heat pump, testing showed the reversing valve and the compressor were both failing. With 107 degrees outside, the gauges flagged the system’s subcooling as below the typical range. The contactor showed worn contacts, and the outdoor fan motor shaft was rusted. A second system, the one serving the main bedroom, has a dented electrical access door that no longer sits flush.

How We Fixed It

  • Tested the outdoor unit’s controls, electrical parts, and refrigerant circuit with gauges connected.
  • Recommended a full system replacement as the long-term fix, since the two parts that make a heat pump work, the reversing valve and the compressor, were both failing.

How it turned out

Replacement was the tech’s recommendation, and the visit ended there. The record doesn’t show what the homeowner decided.

Is cold air in heat mode ever normal?

Yes, for a few minutes at a time. In defrost, a heat pump switches to cooling briefly to melt frost off the outdoor coil, and the vents can feel cool until it switches back. Many systems bring on backup heat during defrost to cover it. Cold air that lasts longer than about 15 minutes, or happens every time the heat runs, needs a check.

Can a reversing valve be replaced by itself?

Yes, but it’s a big job on the refrigerant side: recover the charge, cut out the old valve, braze in the new one, pull a vacuum, and recharge. When the compressor is failing at the same time, the repair covers most of the expensive parts of the system. Our compressor repair vs. replace write-up explains how to weigh it.

Why do heat pumps wear out faster in Las Vegas?

A heat pump here works most of the year: months of cooling in 100-plus heat, then heating on cold winter nights. More run hours mean more wear on the compressor and valve. See why ACs fail early in Las Vegas and our full system replacement guide.

Expert insight

“A heat pump depends on two parts to heat: the reversing valve and the compressor. When testing shows both are failing, repairing one doesn’t make sense. On this job we recommended a full replacement as the long-term fix and explained why before the homeowner decided.”
Luis Perez, Install Manager at Bob's Repair
Luis PerezInstall Manager

Safety note: HVAC repairs involve high voltage, refrigerant and, on gas furnaces, combustion gases. Leave them to a licensed technician.

Team of Bob's Repair technicians in Paradise, NV, performing maintenance on outdoor AC units to extend their lifespan, set against the backdrop of a local home and a palm tree.

Why Bob's Repair

3,000+Google reviews across our offices

Licensed in NevadaNV license 0085640 | 0088730

4 officesacross the Las Vegas valley

Open 7 daysa week

Chat with Bob's Repair