Why Is My Furnace Blowing Cold Air? A Sticking Gas Valve in Las Vegas

A furnace blows cold air when the blower runs but the burners aren’t lit or won’t stay lit. The usual reasons are a gas valve that doesn’t open, a failed igniter or flame sensor, an overheating safety shutdown, or a thermostat fan set to On. On October 13, 2026, we checked an older rooftop gas package unit at a Las Vegas home in the 89121 ZIP that was blowing cold air and cutting out on and off. The tech found an intermittently sticking gas valve and motors that were overheating.

Why Is My Furnace Blowing Cold Air? A Sticking Gas Valve in Las Vegas

What We Found

The heat had quit and the vents were blowing cold air. On the roof, the package unit’s heating section holds a Honeywell gas valve, an inducer motor, the heat exchanger, and the main blower. The tech traced the on-and-off failures to a gas valve that sometimes sticks, which keeps gas from reaching the burners while the blower keeps moving air. The tech also reported overheating motors, and both the inducer motor and the blower motor were coated in dust.

How We Fixed It

  • After a reset, the heat came back on and was running during the visit.
  • Reviewed the repair options for the gas valve and motors, along with a full system replacement.
  • The homeowner chose to keep using the heat while it works and call if it stops again.

How it turned out

The heat was running after the reset. A gas valve that sticks once tends to stick again, so the visit ended with repair and replacement options on the table and a plan to call if the heat fails.

Could it just be the thermostat?

Check that first. If the fan is set to On, the blower runs nonstop and pushes room-temperature air between heating cycles. Set it to Auto, make sure the mode is Heat, and set the temperature a few degrees above the room.

What else makes a furnace blow cold air?

Ignition problems are next on the list. A worn hot surface igniter or a dirty flame sensor can keep burners from lighting. A furnace that starts, then shuts off can point to a pressure switch or venting problem.

Why would furnace motors overheat?

Dust, worn bearings, and age. A dust-coated motor can’t shed heat well, and an overheating motor can trip its own protection. Heat that builds up in the cabinet can also trip the high-limit switch, which shuts the burners off while the blower keeps running. That’s another route to cold air from the vents. A furnace cleaning clears that dust.

Expert insight

“A gas valve that sticks once tends to stick again. On this job a reset brought the heat back, and we said clearly that it was a reset, not a repair. We reviewed the repair and replacement options, and the homeowner chose to keep using the heat and call if it stops.”
Fred Prandecki, Co-owner at Bob's Repair
Fred PrandeckiCo-owner

Safety note: HVAC repairs involve high voltage, refrigerant and, on gas furnaces, combustion gases. Leave them to a licensed technician.

Team of Bob's Repair technicians in Paradise, NV, performing maintenance on outdoor AC units to extend their lifespan, set against the backdrop of a local home and a palm tree.

Why Bob's Repair

3,000+Google reviews across our offices

Licensed in NevadaNV license 0085640 | 0088730

4 officesacross the Las Vegas valley

Open 7 daysa week

Chat with Bob's Repair